Configuring System Settings; Basic Settings Example - Yamaha MMP1 Operation Manual

5. Configuring System Settings

The explanations provided here assume that input from the DAW is sent to the Main Monitor (5.1 ch) and the near field
monitor (L/R), and the system supports both Cue output (L/R) and Studio Speaker output (L/R). Once you get used to
configuring system settings in the following manner, make the necessary adjustments to settings to match your operating
environment.
NOTE
The MMP1 system treats Main Monitor 1/2 as L and R respectively for some functions. While it is possible to establish a flexible system
configuration that is not specialized to any specific format, a system design where Main Monitor 1/2 is interpreted as L/R is recommended.

5-1. Basic settings example

This example is based on the system outlined in the following block diagram.
Nuendo 5.1 Out
(Dante input 1-6)
CD
(AES/EBU input 1/2)
Cue Out
Cue Mix Source
(Dante input 7/8)
Preamp Out
(Analog input 1)
Preamp Out
(Analog input 2)
Mixer Talkback
(Analog input 3)
Director Talkback
(Analog input 4)
5-1-1. Preparation
1.
Launch the MMP1 Editor, and then log in
"Offline" mode as an "Administrator."
"Administrator" privileges are required to configure
settings.
Dim Mute Level
Mute Level
Talkback
Mute Level
Talkback
Mute Level
2.
Select the sample rate.
Settings screen - Scene - MISC
5. Configuring System Settings
Speaker Set A
(Analog output 1-6)
Bass
Speaker Set B
Management
(Analog output 7/8)
Headphone
(AES/EBU output 5/6)
Cue Out
(AES/EBU output 1/2)
Studio Speaker Out
(AES/EBU output 3/4)
DAW
(Dante output 1)
DAW
(Dante output 2)
MMP1 Operation Manual 52