Yamaha MMP1 Operation Manual page 48

Common items for all tabs
Channel name Displays the channel name.
NOTE
The channel name can be set in the MMP1
Editor.
Shows the status of mics controlled with the
Commentary functions.
Shows the mic audio is being input.
Shows that the mic user has muted
mic audio.
Shows that the mic on and off
control by the mic user is disabled.
NOTE
When the Commentary functions are not
being used, you can hide the functions using
"Show Cough Status" on the Preference
screen.
SOURCE A/ Switches between channel strip input
sources.
SOURCE B
COMMON tab
Switches between the signal phases
(normal phase/reversed phase (green)).
Turns Insert on (green) or off.
INSERT
Send Destination Select the signal to send to the Insert.
Return Source Select the signal to be returned from the
Insert.
(Insert) Trim Drag to adjust signal levels to be sent to
the Insert. Double tap to return this value
to 0.
SIGNAL CHAIN Displays the signal processors applied to
audio signals in the order in which they
are applied (descending order).
Trim Drag to adjust the output level for the
selected channel. Double tap to return
this value to 0.
PFL Turns output to the PFL (Pre Fader Listen)
bus on (green) or off. Turn this on to send
pre fader audio signals to Main Monitors
1 and 2 while muting outputs from Main
Monitor 3 onwards.
AFL Turns output to the AFL (After Fader
Listen) bus on (green) or off. Turn this on
to send post fader audio signals to Main
Monitors 1 and 2 while muting outputs
from Main Monitor 3 onwards. When
"PFL" is on, signals will not be sent to the
Main Monitors even when this button is
turned on.
MUTE Turns mute on (yellow) or off.
Drag to change the pan. Double tap to
return this value to C.
PRE Tap to change the position (pre fader/
post fader) of the signal displayed on the
POST
meter.
Level meter Values less than -20 dB are displayed in
green , values less than 0 dB in
yellow , and values equal to or above
that in red . Peak hold circuits are not
displayed. Whether pre fader or post
fader values are displayed is changed
using "PRE" and "POST."
Fader Drag to set the level.
Output level Displays the output level.
4. Screens
MMP1 Operation Manual 48