GE C60 Instruction Manual page 64

4.2 FACEPLATE INTERFACE
3. Press the MESSAGE
display.
SETTINGS
## SETTINGS
## PRODUCT SETUP
4
4. After the 'CHANGE...PASSWORD' message appears on the display, press the VALUE
change the selection to Yes.
5. Press the key and the display will prompt you to 'ENTER NEW PASSWORD'.
6. Type in a numerical password (up to 10 characters) and press the
7. When the 'VERIFY NEW PASSWORD' is displayed, re-type in the same password and press
8. When the 'NEW PASSWORD HAS BEEN STORED' message appears, your new SETTING (or COMMAND) PASS-
WORD will be active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding Encrypted Password from the PASS-
WORD SECURITY menu to the Factory for decoding.
4-14
key until the 'CHANGE SETTING (or COMMAND) PASSWORD:' message appears on the
"
# PASSWORD
# SECURITY
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
C60 Breaker Management Relay
4 HUMAN INTERFACES
ACCESS LEVEL:
Restricted
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ----------
ENCRYPTED SETTING
PASSWORD: ----------
key or the VALUE
key.
ENTER NEW
PASSWORD: ##########
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
key to
.
GE Multilin