GE C60 Instruction Manual page 180

7.1 COMMANDS
This menu contains commands for clearing historical data such as the Event Records. Data is cleard by changing a com-
mand setting to "Yes" and pressing the
"
PATH: COMMANDS SET DATE AND TIME
## COMMANDS
## SET DATE AND TIME
The date and time can be entered here via the faceplate keypad, provided that the IRIG-B signal is not being used. The
time setting is based on the 24-hour clock. The complete date, as a minimum, must be entered to allow execution of this
command. The new time will take effect at the moment the
"
PATH: COMMANDS RELAY MAINTENANCE
## COMMANDS
## RELAY MAINTENANCE
This menu contains commands for relay maintenance purposes. Commands are activated by changing a command setting
to "Yes" and pressing the
The
PERFORM LAMPTEST
command causes the relay to scan the backplane for the hardware modules and update the order code to
ORDER CODE
match. If an update occurs, the following message is shown.
7
There is no impact if there have been no changes to the hardware modules. When an update does not occur, the following
message will be shown.
7-2
CLEAR BREAKER 2
ARCING AMPS? No
CLEAR DEMAND
RECORDS?: No
CLEAR ENERGY?
No
key. After clearing data, the command setting automatically reverts to "No".
SET DATE AND TIME:
2000/01/14 13:47:03
PERFORM LAMPTEST?
No
UPDATE ORDER CODE?
No
key. The command setting will then automatically revert to "No".
command turns on all faceplate LEDs and display pixels for a short duration. The
UPDATING...
PLEASE WAIT
ORDER CODE
NOT UPDATED
C60 Breaker Management Relay
7 COMMANDS AND TARGETS
Range: No, Yes
Range: No, Yes
Range: No, Yes
7.1.4 SET DATE AND TIME
(YYYY/MM/DD HH:MM:SS)
key is clicked.
7.1.5 RELAY MAINTENANCE
Range: No, Yes
Range: No, Yes
UPDATE
GE Multilin