ABB COM600 series User Manual page 54

54
COM600 series, Version 5.0
IEC 60870-5-103 Master (OPC) User's Manual
13857 Message buffer full. The value of the Message Length parameter may be too
small.
13858 Message filling error. The value of the Message Length parameter may be too
small.
13863 Device suspended. The reason could be that the link is not properly established
(for example, incorrect communication cable wiring) or the client station does
not respond.
13864 Message sending error. The error may be the result of a problem in communic-
ation cable wiring or hardware.
13865 Remote device replies with no acknowledged response. The client did not accept
the message but responded with a negative acknowledgment instead. Not used
in the unbalanced mode.
13866 Link not ready. A message is sent to a link with a non-established communication.
13870 Confirmation timeout. An activation confirmation to a command was not received
from the IEC client in the time defined by the Reply Timeout parameter.
13871 Negative confirmation received. The activation confirmation received from the
IEC client was negative, that is, the command failed.
13872 Device taken out of use.
13881 Device taken in use.
17600 Remote link continuously busy. The Data Flow Control (DFC) bit of the messages
from the client is set for more than 15 s.
17601 Timeout while transmitting. The CTS signal or the end of transmitted message
is not received in correct time. The DE attribute controls the CTS waiting time;
the transmission time of the message is automatically calculated.
17602 Timeout while waiting for an acknowledgment to a message.
17604 Link not ready. The application level sends a command before the communication
between the server and the client is established.
17605 Remote link busy.
17606 Remote link not responding. The server does not receive a reply from the client.
17607 Channel set in use.
17608 Channel set out of use.
17610 Receiver out of buffers.
17611 Dial-up function inactivated.
17612 Dial-up function activated.
1MRS752278