Parameters Mode; Start-Up Assistant Mode - ABB ACS550-01 User Manual

ACS550 User's Manual
– Download restores the parameters into the drive.
– A partial restore option excludes the following parameters from the backup:

Parameters Mode

Use the Parameters mode to manually set parameters:
• Select PARAMETERS in the Main Menu.
• Press the UP/DOWN buttons to highlight the
appropriate parameter group, then press SEL.
• Press the UP/DOWN buttons to highlight the
appropriate parameter in a group.
NOTE! The current parameter value appears below the
highlighted parameter.
• Press EDIT.
• Press the UP/DOWN buttons to increment the
parameter value.
Note! To view the parameter default value in the set
mode, press the UP/DOWN buttons simultaneously.
• Press SAVE to store the modified value or press CANCEL to leave the set mode.
Any modifications not saved are cancelled.
• Press EXIT to return to the listing of parameter groups, and again to return to the
main menu.

Start-up Assistant Mode

The Start-up Assistant guides you through the basic programming of a new drive.
(You should understand basic control panel operation as described in "Controls/
Display Overview" on page 26.) The assistant also checks the values entered to
prevent entries that are out of range. At the first start, the drive automatically
suggests entering the first task, Language Select.
The Start-up Assistant is divided into tasks. You may activate the tasks one after the
other, as the Start-up Assistant suggests, or independently. (You are not required to
use the assistant, you may use instead, the parameter mode to set the drive
parameters.)
The order of the tasks presented by the Start-up Assistant depends on your entries.
The task list in the following table is typical.
9905...9909, 1605, 1607, 5201, and all Group 51 parameters.
29
Start-Up