Toshiba e-STUDIO163 Service Handbook page 96

[B] Image position adjustment of the primary scanning direction
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Place a ruler on the original glass with its leading edge pushed against the rear side and its side
along the original scale on the left.
(3) Make a copy at the mode of A3 (LD), 100% and standard drawer of the equipment.
(4) Measure the distance B from the left edge of the paper to 10 mm of the copied image of the ruler.
(5) Check if the distance B is within the range of 10±0.5 mm.
(6) If not, use the following procedure to change values and repeat the steps (1) to (5) above.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
Press the [ENTER] or the [INTERRUPT] button (stored in memory).
("100% A" is displayed.)
* The smaller the adjustment value is, the more the image is shifted to the left and the distance
B becomes narrower (0.085 mm/step).
e-STUDIO163/203 ADJUSTMENT
(Key in the code [306])
Copied image of the ruler
Fig. 3-10
(Adjustment Mode)
[START]
Feeding direction
3 - 12
December 2005 © TOSHIBA TEC