Toshiba e-STUDIO163 Service Handbook page 86

(4) After about two minutes, the value B automatically starts changing.
(5) After a short time, the value B becomes stable and the display changes as follows.
(6) Check if the value B is within the range of 232 to 248 (the output voltage range of the auto-toner
sensor is 2.32 V to 2.48 V).
(7) If the value B is not within the range of 232 to 248, press the Up or Down button to adjust the
value manually.
Note: Note:
The relation between the button and the values A and B is as follows.
Button to be pressed
Up
Down
(8) Press the [ENTER] or [INTERRUPT] button.
The drum, developer unit, etc. are stopped and the following is displayed.
(9) Turn the power OFF.
(10) Install the toner cartridge.
e-STUDIO163/203 ADJUSTMENT
T .B.D
Fig. 3-3
T.B.D
Fig. 3-4
Value A
Increased
Decreased
T .B.D
Fig. 3-5
3 - 2
Value B
Increased
Decreased
December 2005 © TOSHIBA TEC