Download Print this page

Toshiba e-STUDIO163 Service Handbook page 161

Multifunctional digital systems
Hide thumbs Also See for e-STUDIO163:

Advertisement

[E13]
Drawer misfeeding (paper not reaching the registration sensor)
Open the transfer cover. Is there any paper in front of the registration sensor?
YES
NO
Is the registration sensor working?
(Perform the input check in the test mode: 03-[INTERRUPT]OFF/[9]/[6])
l
NO
l
l
l
l
l
l
l
YES
Is the pickup solenoid working?
(Perform the output check in the test mode: 04-201)
l
NO
l
l
l
l
l
l
l
l
YES
Check the drawer feed roller, separation roller and pickup roller.
Replace them if they are worn out.
December 2005 © TOSHIBA TEC
Remove the paper.
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN26 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the registration sensor.
6) Replace the MAIN board.
1) Check if the connector of the pickup solenoid is disconnected.
2) Check if the connector CN26 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the pickup solenoid.
6) Replace the MAIN board.
5 - 5
e-STUDIO163/203 TROUBLESHOOTING
5

Advertisement

loading

This manual is also suitable for:

E-studio203