Setting And Changing Function 34 - Panasonic AAD03011 Instruction Manual

Setting and Changing Function
Various function data can be changed and set when the operation is stopped.
Note that some functions can be changed during operation.(See page 35)
Setting functions when operation is stopped.
[Setting example: Change the maximum frequency from 50Hz to 60Hz.]
(Changing the parameter P03 data from "50" to "60".)
STOP Press the STOP button to stop the inverter
MODE Press the MODE button
MODE Press the MODE button
MODE Press the MODE button
Press the MODE button(Enter the function
MODE
setting mode)
(if a password is set, it must be entered at this
point. See page 53.)
Press the (UP) button twice, and change the
parameter No. to P03.
SET Press the SET button to display the parameter
P03 data.(The main display will flicker.)
Press the
display value to "60". (The main display will flicker.)
SET Press the SET button to set the data.
Press the MODE button to make the
MODE
status ready for operation.
OPERATION PREPARATION
COMPLETED
[Setting Precautions]
1 After the function is set, the inverter will not run unless the MODE button is pressed and
the "operation preparation completed" state is returned to.
2 If the function setting returns to the "operation preparation completed" state during data
changing, while a start input signal is being applied through external control, an "OP"
error will be displayed, causing the inverter to remain inoperative.
Reset the fault indication using the instructions under "Resetting Fault Trips" (page 90).
3 The set data will be stored in the memory even after the power supply has been turned OFF.
34
(UP)button, and change the data
...The normal stop state will be entered and
the inverter can be run.
Main display
0 0 0
F r
d r
n 0
P 0
P 0
5 0
6 0
P 0
0 0 0