Metering; Flexelements; Rxgoose Analogs - GE C30 Instruction Manual

METERING

The C30 is provided with optional PRP capability. This feature is specified as a software option at the time
of ordering. See the Order Codes section in chapter 2 for details
Total Received Port A
Total Received Port B
is a counter for total messages received with an error (bad port code, frame length too short).
Total Errors
Mismatches Port A
and LAN ID in the frame do not match).
Mismatches Port B
and LAN ID in the frame do not match).
6.3 Metering

6.3.1 FlexElements

ACTUAL VALUES  METERING  FLEXELEMENTS  FLEXELEMENT 1(8)
 FLEXELEMENT 1

6 The operating signals for the FlexElements are displayed in pu values using the following definitions of the base units.
Table 6-1: FlexElement base units
Base unit
DCmA
FREQUENCY
PHASE ANGLE
POWER FACTOR
RTDs
SOURCE CURRENT
SOURCE POWER
SOURCE VOLTAGE

6.3.2 RxGOOSE analogs

ACTUAL VALUES  METERING  RxGOOSE Analogs
 RxGOOSE
 Analogs
6-10
Mismatches Port A:

Mismatches Port B:

is a counter for total messages received (either from DANPs or from SANs) on Port A.
is a counter for total messages received (either from DANPs or from SANs) on Port B.
is a counter for total messages received with an error on Port A (PRP frame, but port received through
is a counter for total messages received with an error on Port B (PRP frame, but port received through
FLEXELEMENT 1

OpSig: 0.000 pu
Description
BASE = maximum value of the DCMA INPUT MAX setting for the two transducers configured
under the +IN and –IN inputs.
f = 1 Hz
BASE

= 360 degrees (see the UR angle referencing convention)
BASE
PF = 1.00
BASE
BASE = 100°C
I = maximum nominal primary RMS value of the +IN and –IN inputs
BASE
P = maximum value of V
BASE
V = maximum nominal primary RMS value of the +IN and –IN inputs
BASE
RxGOOSE Analog 1

0.000
RxGOOSE Analog 32

0.000
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
 I
for the +IN and –IN inputs
BASE BASE

C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES