Bosch C 60 Manual page 193

GPS Sensor
GPS Sensor
Troubleshooting

Electrical

Is the transmitter signal of the GPS sensor connected to the

receiver pin of serial interface 2 of the C 60?
Is the GPS sensor powered up?

Does the GPS sensor deliver RS232 signal levels?

Interface

Do the baudrates of the GPS sensor and the DDU match?

Is the GPS sensor set up for 8N1 transmission parameters?

Is the GPS sensor set up for NMEA messages?

Are the GGA, VTG, RMC messages activated?

With a correctly wired and powered GPS sensor the changing GPS time information

(gps_sec) can be immediately observed
Is Software Upgrade 2 activated in the C 60?

GPS sensor start-up

Does the GPS sensor 'view' the sky?

Did the GPS sensor complete its initial start-up procedure? This may take up to 20min.

A correct reception is indicated when gps_fix is showing "3D Fix"

Motorsport
193
Internal | BEG/EMS1 CsM | 6/4/2010 | © Bosch Engineering GmbH 2009. All rights reserved, also regarding any disposal, exploitation,
reproduction, editing, distribution, as well as in the event of applications for industrial property rights.