Bosch C 60 Manual page 125

C 60 Online Measurement
C 60 Online Measurement + Calibration
Group adjustment

Triggering the group adjustment

Double click on the input channel of the group adjustment.

Make sure the pull-up resistor is enabled, if you selected 'active low' trigger polarity

Connect the input pin to GND using a push-button

Download the configuration on the C 60

Drag the 'grp_adj_channel' and the 'input_grp_adj_channel' to an online measurement sheet

Press and release the push-button

The measurement labels indicate the state of the input pin and the state of the adjustment

Hint: A display alarm can be linked to the trigger channel indicate that the trigger has been detected

Drag channels on
measurement
sheet
Motorsport
125
Internal | BEG/EMS1 CsM | 6/4/2010 | © Bosch Engineering GmbH 2009. All rights reserved, also regarding any disposal, exploitation,
reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Voltage at
input pin
State of adjustment
0 - Idle
1 - Adjustment triggered
2 - Adjustment lock time