Di Water Connection (Pressurised) Ö 60 - 1000 Kpa (9 - 145 Psi); Di Water Connection (Without Pressure) 8.5 - 60 Kpa (1.23 - 9 Psi) (Optional) - Miele G 7883 Operating Instructions Manual

Plumbing
– Large surface area filters are
enclosed in the kit supplied with the
machine for installing between the
stopcock and the inlet hose (see
illustration in "Maintenance -
Cleaning the filters in the wash
cabinet'"). The large surface area
filter for the DI water supply is made
from chrome nickel steel, and can be
recognised by the matt top surface.
,
The inlet hoses must not be
shortened or damaged in any way
(see illustration).
See also the installation diagram
supplied.
70
DI water connection (pressurised)
ö 60 - 1000 kPa (9 - 145 psi)
The machine is supplied as standard
for connection to an DI water supply of
60 - 1000 kPa (9 - 145 psi). If the water
pressure (flow rate) is below 150 kPa
(22 psi) the water intake time is
automatically extended.
^ The DI pressure tested hose (marked
"H O pur") with a 3/4" threaded union
2
must be connected to the on-site DI
stopcock for purified water.
,
If the DI water supply is not
used, the electronics must be
re-programmed by a Miele service
technician. The inlet hose will remain
on the rear of the machine.
DI water connection (without
pressure) 8.5 - 60 kPa (1.23 - 9 psi)
(optional)
If the machine has not been set up for
use with a non-pressurised DI water
supply (special order), it has to be
converted for use with 8.5 - 60 kPa
(1.23 - 9 psi) water supply, and fitted
with a feed pump by a Miele service
technician.
When connecting an DI water
container (without pressure), the
drain connection must be at least
the height of the upper edge of the
machine (see "Installation
instructions").