Table of Contents
Advertisement
INCUBATOR COMPONENTS
12. Set key (SET): Pressing this key to enter the setting mode, and the digits to be set will flash.
13. Calibration key (CAL): By pressing this key for approximately 5 seconds, the unit enters calibration
function mode. Also, used to change the UV lamp ON period. See page 36 and 24 for the details.
14. Alarm buzzer stop key (BUZZER): Press this key to silence the buzzer when the alarm operates
and the buzzer sounds.
15. N
/O
gas supply line indicator (A/B): The lamp for the supply line currently in use lights up.
2
2
(Lamp ON; cylinder A, Lamp flash; cylinder B)
16. CO
gas supply line indicator (A/B): The lamp for the supply line currently in use lights up
2
provided that MCO-5GC changeover accessory is installed. (Lamp ON; cylinder A, Lamp flash; cylinder
B)
17. Gas supply line switching key (GAS SUPPLY): This is a key to select N
pressing this key, the N
is changed automatically when N
density set mode, CO
changeover MCO-5GC (option) is installed. The supply line is changed automatically when CO
cylinder is empty.
18. Enter key (ENT): Pressing this key memorizes the set value in the controller.
19. Numerical value shift key (
to shift. In key lock mode, pressing this key makes key lock ON or OFF.
20. Digit shift key (
Pressing this key more than 5 seconds enters key lock mode. See page 27 for the key lock.
12
20
or O
gas supply line (A/B) is changed in O
2
2
or O
gas cylinder is empty. Similarly, by pressing this key in CO
2
2
gas supply line is changed automatically when an automatic gas cylinder
2
): Pressing this key in the setting mode causes the numerical value
): Pressing this key in the setting mode causes the changeable digit to shift.
13
14
16
19
18
density set mode. The supply line
2
70
15
17
or O
gas supply. By
2
2
2
gas
2
14
Hide quick links:
Advertisement
Table of Contents
