2.2.18. Toner Sensor (513), Laser Unit [LSU] (512), SNS3 PC Board (1009)
(2)
(4)
(6)
(9)
(1) Remove the Transmit Guide Assembly
(2) Remove 2 Screws (19).
(3) Remove Ground Wire (542).
(4) Remove the CCD Shield Plate (533).
(3)
(5) Remove 1 Screw (19).
(6) Disconnect Connector CN84 on the SNS3 PC Board
(5)
(7)
(7) Remove the Toner Sensor Spring Plate (506)
Note:
(8) Remove the Toner Sensor (513).
(9) Disconnect the Connector on the Toner Sensor.
(8)
(Refer to 2.2.4.).
(1009).
Assembly.
When reinstalling, make sure that the Toner Sensor
Spring Plate is inserted into the 2 notches in the main
frame as illustrated.
48