Module Ekip Programming; Ekip Tt Module - ABB SACE Emax 2 Installation, Operation And Maintenance Instructions

Module Ekip Programming

Ekip TT module

69 | © 2014 ABB | 1SDH000999R0002 - L8569
Ekip Programming allows you to:
• In the absence of auxiliary voltage, to supply the release.
• With Ekip Connect software (see page 67), access the information and pages for programming the release.
IMPORTANT: Ekip Programming can be connected the releases also when they are
in service.
NOTE: Ekip Programming only powers the release. Therefore, to set and display the information
for any electronic accessories connected to the terminal box, those accessories must be
powered with an Ekip Supply module (see page 61).
It draws its power from the PC, and connects one side directly to the test connector at the front of the
release, and on the other to the USB ports of the PC with the cable supplied.
It turns on after connecting to the PC, and is equipped with two LEDs, a green one indicating that the module
is on, and a yellow one indicating active communication.
Ekip TT is supplied as standard with Ekip Dip releases not mounted on a circuit-breaker, and with Touch, Hi-
Touch, G Touch, and G Hi-Touch releases, and allows the following:
• Check that the opening mechanism of the circuit-breaker functions properly by commanding an opening
by means of the test procedure.
• In the absence of auxiliary voltage and where the circuit breaker is open due to a protection tripping, power
the release so that you can see which protection tripped either on the display or through the lighting of
the corresponding LEDs.
• In the absence of auxiliary voltage, power the Ekip Touch, Hi-Touch, G Touch, and G Hi-Touch releases
in order to set the protections.
IMPORTANT: Ekip TT can also be connected to the releases when in service. In the
case of connection to releases in service, it is not possible to perform a trip test.
NOTE: the Ekip TT only powers the release. Therefore, in order to set and to display information
on any electronic accessories connected to the terminal box, these must be powered with
an Ekip Supply module (see page 61).
Draws its power from three AA alkaline batteries 1.5V, connects to the test connector at the front of the trip
unit with the supplied cable, and is turned on by setting the side switch to ON.
It includes a led that is green when the device is energized and the batteries are charged, and red when the
batteries are drained and need to be replaced.
Further information on Ekip TT is available from the web site http://www.abb.com/abblibrary/
DownloadCenter/, in particular in the kit sheet 1SDH001000R0519, and in the Ekip Connect software manual
1SDH000891R0002.
ABB | SACE Emax 2
Electronic accessories | 4 - Other accessories