NEC UNIVERGE SV8300 Command Manual page 69

COMMAND CODE
04
Y
No. MEANING
10 Unit No. 01-50
59
TITLE:
DISPLAY LANGUAGE FOR MULTILINE TERMINAL/DESKCON LCD, DEFAULT SETTING
PATTERNS FOR MULTILINE TERMINAL, KIND OF TONE FOR IP STATION/TDM, INQUIRY
NO. IN PASSWORD LOCK STATE FOR DT700 SERIES, SINGLE LINE TELEPHONE
RINGING SIGNAL FOR STATION-TO-STATION CONNECTION, SINGLE LINE TELEPHONE
RINGING SIGNAL FROM A TRUNK, SPECIAL RINGING SIGNAL FOR SINGLE LINE
TELEPHONE RING, SETTING OF SERVICES, A-LAW/µ-LAW SETTING FOR EACH UNIT
1ST DATA
DATA MEANING
01 Destination to receive the
synchronous signal for
DTI/PRT/CCT (First pri-
ority)
BLADE RESET
NOTE 1:
Assign this data when the system is a slave office and receives the clock syn-
chronization signal from the master office.
This data assignment is not required when the office is the master office.
NOTE 2: When using the ISDN network, a system must be synchronized to ISDN clocks
for preventing from noise during calling, data transmitting error, and so on.
NOTE 3: This data must be set when using the ISDN network.
02 Destination to receive the
synchronous signal for
DTI/PRT/CCT (Second
priority)
BLADE RESET
NOTE 1: Assign this data when the system is a slave office and receives the clock syn-
chronization signal from the master office.
This data assignment is not required when the office is the master office.
NOTE 2: When using the ISDN network, a system must be synchronized to ISDN clocks
for preventing from noise during calling, data transmitting error, and so on.
2ND DATA
DATA
01 Slot No.
18
NONE No data
01 Slot No.
18
NONE No data
3-20
: Default
RELATED
COMMAND
MEANING
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM04