NEC UNIVERGE SV8300 Command Manual page 324

COMMAND CODE TITLE:
41
1ST
Y MEANING
DATA
Expire value for
DT700 Series REGIS-
TER (Day)
RESET
130
0
Expire value for
DT700 Series REGIS-
131
TER (Hour)
RESET
Expire value for
DT700 Series REGIS-
132
TER (Minute)
RESET
SYSTEM TIMER DATA
DEFAULT
NONE 00 01 02 .........................................................99
180 0
seconds
NOTE 1:
Usually, this data setting is not required.
NOTE 2:
This data implies the expire value for the DT700 Series
REGISTER (terminal registration) and is set by the
combination of CM41>130-132 (day/hour/minute).
When CM41>130-132 (day/hour/minute) are all set to
NONE, the expire value "180 seconds" is set as default.
NOTE 3: The DT700 Series updates the REGISTER at half interval
of the value set by this data.
NOTE 4: The load to SV8300 increases if small amount of data
(such as 1 minute) is set. Therefore, it is recommended to
set the value more than 180 seconds.
NONE 00 01 02 .........................................................23
180 0
seconds NOTE:
NONE 00 01 02 .........................................................59
180 0
seconds NOTE:
2ND DATA
TIMER
1 2 ..........................................................99
1 2 ..........................................................23
See NOTE 1 through NOTE 4
1 2 ..........................................................59
See NOTE 1 through NOTE 4
3-275
INCREMENT
UNIT
1 day
1 hour
on CM41>130.
1 minute
on CM41>130.
Continued on next page
NWA-033623-001 Rev.3.0
91ch3004.fm
JULY/18/2008
CM41