NEC UNIVERGE SV8300 Command Manual page 30

NOTE 6:
The standard system data is the data which shall be valid for the following data.
• Station number 300 (for Digital Multiline Terminal) for Physical Port number 010101
• Station number 301 (for IP Multiline Terminal) for Virtual Port number 0000 (for IP termi-
nal)
In addition, ensure that the Unit numbers 01-04 operate together. The standard system data
is loaded for using CAT features.
(3) Do not change or delete the My Line number (set by CM10 Y=00) of the CAT, during CAT mode.
(4) There are no limitations on the number of Multiline Terminals in the system that can be programmed
to allow CAT capability. However, the number of Multiline Terminals that can be placed into CAT
mode, at the same time, is two.
If no key operation is executed for about 10 minutes, the CAT mode is canceled.
(5) When you use a D
CAT is expanded to 24-digit.
NOTE:
Do not use
quired.
(6) Soft Phone cannot be used for CAT.
term
70 (Elite)/75 (Series E) for CAT, press
( ) key in the above (5) operation.
ST REDIAL
ST
1-15
Chapter 1 HOW TO USE CAT
NOTICE ON CAT MODE
(Exit) key so that the display of
(Exit) key operation is re-
ST
NWA-033623-001 Rev.3.0
91ch1001.fm
JULY/18/2008