Setting An Example Layer 2 Dynamic Aggregation Configuration - HP A5830 Configuration Manual

Setting an example Layer 2 dynamic aggregation configuration

Network requirements
As shown in
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces

GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
Configure a Layer 2 dynamic aggregation group on Device A and Device B. Then enable VLAN 10

at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at
one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and

destination MAC addresses.
Figure 9 Network diagram for Layer 2 dynamic aggregation
VLAN 10
GE1/0/4
Device A
GE1/0/5
VLAN 20
Configuration procedure
Configure Device A.
1.
# Create VLAN 10, and assign the port GigabitEthernet 1/0/4 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port gigabitethernet 1/0/4
[DeviceA-vlan10] quit
# Create VLAN 20, and assign the port GigabitEthernet 1/0/5 to VLAN 20.
[DeviceA] vlan 20
[DeviceA-vlan20] port gigabitethernet 1/0/5
[DeviceA-vlan20] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link-aggregation mode as
dynamic.
[DeviceA] interface bridge-aggregation 1
[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic
# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to link-aggregation group 1 one
at a time.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1
Figure 9:
GE1/0/1
GE1/0/2
Link aggregation 1
GE1/0/3
BAGG1
VLAN 10
GE1/0/1
GE1/0/2
GE1/0/3
BAGG1
VLAN 20
42
GE1/0/4
Device B
GE1/0/5