Setting The Vlan Transparent Transmission Configuration - HP A5830 Configuration Manual

Configure GigabitEthernet 1/0/3.

# Configure GigabitEthernet 1/0/3 as a trunk port and assign it to VLAN 100.
[PE2] interface gigabitethernet 1/0/3
[PE2-GigabitEthernet1/0/3] port link-type trunk
[PE2-GigabitEthernet1/0/3] port trunk permit vlan 100
# Configure VLAN 100 as the PVID for the port.
[PE2-GigabitEthernet1/0/3] port trunk pvid vlan 100
# Enable basic QinQ on the port.
[PE2-GigabitEthernet1/0/3] qinq enable
[PE2-GigabitEthernet1/0/3] quit
Configure third-party devices.
3.
On the third-party devices between PE 1 and PE 2, configure the port that connects to PE 1 and that
connecting to PE 2 to allow tagged frames of VLAN 100 and VLAN 200 to pass through.

Setting the VLAN transparent transmission configuration

Network requirements
As shown in
The two branches of a company, Site 1 and Site 2, are connected through the service provider

network and uses VLANs 10 through 50.
 PE 1 and PE 2 are edge devices on the service provider network and are connected through third-
party devices with a TPID value of 0x8200.
Configure the edge and third-party devices to allow frames of VLANs 10 through 50 to be

transmitted between the branches of the company via the service provider network with no outer
VLAN tags added.
Figure 52 Network diagram for VLAN transparent transmission configuration
PE 1
Site 1
VLANs 10 to 50
Configuration procedure
Be sure that you have configured the switches in the service provider network to allow QinQ packets to
pass through.
Configure PE 1.
1.
Figure 52:
GE1/0/2
VLANs 10 to 50
TPID = 0x8200
GE1/0/1
Public network
CE 1
PE 2
GE1/0/2
GE1/0/1
CE 2
VLANs 10 to 50
155
Site 2