Setting Parallel Tally - Sony CCP-8000 System Setup Manual

3-7-6. Setting Parallel Tally

Engineering Setup → Router/Tally → Parallel Tally
Page 7366
The Parallel Tally output provides the relay contact. This menu is used to enable the Parallel Tally to directly turn
ON/OFF the tally lamp. In this setting, terminal numbers of the virtual inputs and the virtual outputs (Monitor
Tally) of the virtual matrix are assigned to the respective pins of the parallel tally connector (DCU-8000).
m
. To use the Parallel Tally, the Tally/GPI Output Board MKS-8701 must be installed in the MKS-8700.
. Assign the terminal numbers of the virtual inputs and the virtual outputs of the virtual matrix to the slot
numbers and the port number of the slot in which the MKS-8701 is installed.
Setting items
System 1
Parallel Tally Setting is required
Device : Selects either DCU1 or DCU2.
Slot No. : Slot number of the MKS-8701 that is inserted in the DCU-8000.
Port No. : Port number of the MKS-8701.
1 1
For the system 1 1 1
Set the Tally Type and assign the virtual terminal number to each pin (pin number and slot number of the
MKS-8701) of the parallel tally.
For the system 2 2 2 2 2
This setting is not required for the system 2 because the system 2 does not use tally.
For the system 3 3 3 3 3
Set the Tally Type and assign the virtual terminal number to each pin (pin number and slot number of the
MKS-8701) of the parallel tally.
MVS-8000 System
SYSTEM SETUP
Menu screen
1 1 1 1 System 2 2 2 2 2
Setting is not required
System 3 3 3 3 3
Setting is required
3-7. Tally Setup
3-35