Mvs-8000 Installation; Rack Mounting - Sony CCP-8000 System Setup Manual

2-2. MVS-8000 Installation

2-2. MVS-8000 Installation

2-2-1. Rack Mounting

The MVS-8000 can be mounted in the 19-inch standard
rack.
To mount the MVS-8000 series in the rack, use the
specified rack mount parts that are supplied with the MVS-
8000 series and follow the procedure described below.
n
If a rack mount parts other than the specified ones are
used, the unit may not be mounted in the 19-inch standard
rack.
Specified rack mount parts
. Support angle
. Bracket
. Support angle fixing screw
(PSW4 x 10 : 7-682-962-01)
. Bracket fixing screw
(B4 x 10 : 7-682-562-04)
1. Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolt or others.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the specified rack mount parts.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
If the screws on the angle are not tightened, the unit may
slip from the rack and fall, causing injury.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with four persons or more.
. Be careful not to catch your fingers or hands in the rack
mount rail or others.
. Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.
2-2
2 pcs
4 pcs
8 pcs
8 pcs
2. Rack mounting procedure
This section describes the rack mounting procedure using
the dedicated system rack mount kit of the MVS-8000.
n
Use the following torque to tighten the screws finally.
Tightening torque : 120 x 10
1. Attach the bracket to the support angle using the
specified four screws.
2. Loosen the screws on the front and rear of the right
and left brackets. Adjust the length of the brackets
according to the depth of the rack.
(The illustration below shows the left bracket.)
Support angle
PSW4 x 10
Bracket
n
Maximum depth of bracket : 750 mm
Minimum depth of bracket : 595 mm
_2
N.m {12.2 kgf.cm}
Bracket
PSW4 x 10
MVS-8000 System
SYSTEM SETUP