Sony CCP-8000 System Setup Manual page 33

3. Attach the right and left brackets to the rack complete-
ly using the specified eight screws.
(The illustration below shows the left bracket.)
Front side
Rack
B4 x 10
Bracket
31.75
4. Tighten the screws (four screws each on the right and
left) for adjusting the length of the bracket completely
(the screws that were loosened in step 2).
5. Remove the front panel.
6. Remove the 16 screws and remove the handles (two
handles each on the right and left) from both sides of
the MVS-8000.
RK5 x 10
Handle
Handle
RK5 x 10
MVS-8000 System
SYSTEM SETUP
Bracket
31.75
Rear side
Rack
B4 x 10
Unit : mm
Handle
Handle
RK5 x 10
RK5 x 10
7. Place the right and left bottom ends of the MVS-8000 on
the support angles, and slide the equipment to the rear.
n
The support angles support the equipment as shown below.
Bracket Support angles
8. Fix the rack angles of the equipment to the rack using
the specified eight screws.
Rack
B5 x 12
Rack angle
B5 x 12
9. Attach the front panel to the equipment.
2-2. MVS-8000 Installation
Bracket
Rack angle
2-3