Yamaha FJR1300-AS Owner's Manual page 31

To reset the average fuel consumption
display, use the select switch to select
the information display that contains
the average fuel consumption display.
Push the "RESET" button briefly so
that the average fuel consumption dis-
play flashes, and then push the "RE-
SET" button again for 2 seconds while
the display is flashing.
TIP
After resetting the average fuel con-
sumption display, "_ _._" will be shown
for that display until the vehicle has
traveled 1 km (0.6 mi).
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
Instantaneous fuel consumption dis-
play:
CRNT FUEL
The instantaneous fuel consumption
display modes "km/L", "L/100km" or
"MPG" show the fuel consumption un-
der the current riding conditions.
 The "km/L" display shows the dis-
tance that can be traveled on 1.0 L
of fuel.
 The "L/100km" display shows the
amount of fuel necessary to travel
100 km.
 The "MPG" display shows the dis-
tance that can be traveled on
1.0 Imp.gal of fuel.
Instrument and control functions
ECA15474
km/L
12.3
3-17
TIP
If traveling at speeds under 10 km/h (6
mi/h), "_ _._" will be displayed.
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
Adjusting the windshield position
To move the windshield up, push
the " " side of the select switch. To
move the windshield down, push
the " " side of the select switch.
Setting mode
MENU
Grip Warmer
Maintenance
Time Trip
Unit
Display
Brightness
Clock
1. Setting mode display
TIP
 The transmission must be in neu-
tral and the vehicle must be
stopped to change settings in this
mode.
 Shifting the transmission into gear
and starting off, or turning the key
to "OFF", saves all settings made,
then exits the setting mode.
Push and hold the menu switch
"MENU" for 2 seconds to enter the set-
ting mode. To exit the setting mode
ECA15474
3
1