Replacing The Interior Light Bulb - Blomberg TSM 1541 i User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
en
Cooling
Food storage
The fridge compartment is for the short-term
storage of fresh food and drinks.
Store milk products in the intended
compartment in the refrigerator.
Bottles can be stored in the bottle holder or
in the bottle shelf of the door.
Raw meat is best kept in a polyethylene bag
in the compartment at the very bottom of the
refrigerator.
Allow hot food and beverages to cool to room
temperature prior to placing them in the
refrigerator.
Attention
Store concentrated alcohol in a container only
standing upright and tightly closed.
Attention
Do not store explosive substances or
containers with flammable propellant gases
(canned cream, spray cans etc.) in the
appliance.
There is a danger of explosion.
Defrosting of the appliance
The fridge compartment defrosts automatically.
The thawing water flows through the drain
channel into a collection container at the back
of the appliance (Fig. 4).
During defrosting, water droplets form at the
back wall of the fridge due to the evaporation.
If not all of the drops run down, they may
freeze again after defrosting competes.
Remove them with a soft cloth dampened with
warm water. Do not use hard or sharp objects.
Check the flow of the thawed water from time
to time. It may become blocked occasionally.
Clean it with a q-tip or similar (see the section
"Cleaning and care").
Replacing the interior
light bulb
Should the light fail to work, proceed as follows.
1- Switch off the circuit breaker or unplug
the power cable.
You may find it useful to remove shelves for
easy access.
2- Use a flat tipped screwdriver to remove the
light diffuser cover.
3- First check that the bulb hasn't worked loose
by ensuring it is screwed securely in the holder.
Plug in the appliance and switch it on.
If the bulb works, replace the light cover by
inserting the rear lug and pushing up to locate
the front two lugs.
4- If the light still fails to work, Switch off the
circuit breaker or unplug the power cable.
Replace the bulb with a new 15 watt (max)
screw cap (E14(SES)) bulb.
5- Carefully dispose of the burnt-out light bulb
immediately.
Replacement light bulb can easily be obtained
from a good local electrical or DIY store.
5
(Fig. 3)
en

Advertisement

Table of Contents
loading

Table of Contents