Toro 30506 Operator's Manual page 5

Media and Additional Parts
Description
Installation instructions
Parts catalog
Certificate of compliance
1
Removing the Cutting Unit
from the Traction Unit
No Parts Required
Procedure
1. Position the machine on a level surface, raise the
cutting unit, engage the parking brake, ensure that the
traction pedal is in the neutral position and the PTO
lever in the Off position, stop the engine, and remove
the key from the switch.
CAUTION
The counterbalance spring is in tension when
the deck is in the lower position (200 series
traction units only).
Always raise the deck before adjusting or
removing the spring.
2. On 200 series traction units only, disconnect the
counterbalance from the traction unit, remove the lock
pins from the brackets, separate the spring tension
assemblies from the brackets, and lay them down on
the deck. Loosely secure the lock pins to the brackets
to prevent losing them
Qty.
(Figure 1).
1 Read before installation
1 Use to reference part numbers
1 CE certification
1. Lock pin
2. Bracket
3. Lower the cutting unit and remove the 4 bolts and nuts
securing lift arm brackets to castor arms
1. Lift arm bracket
4. Start the engine and raise the traction unit lift arms.
5. Stop the engine and slide the cutting unit away from the
traction unit, separating the male and female sections
of PTO shaft
5
Use
Figure 1
3. Spring tension assembly
Figure 2
2. Right castor arm
(Figure 3).
(Figure 2).