Removing The Aerator From The Crating; Connecting The Lower Link Arms - Toro 09930 Operator's Manual

Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Spring Wires - SR48
Spring Wires - SR48
Spring Wires - SR54 & SR54-S
Spring Wires - SR70 & SR70-S
Spring Wires - SR72
Spring Wires - SR72
Spring Wires - SR75
Spring Wires - SR75
Operator training materials
PTO Operators Manual
1
Removing the Aerator from
the Crating
No Parts Required
Procedure
1. Remove the aerator from the crating.
2. Remove the bolts securing the aerator storage stands
to the shipping pallet and remove the aerator from
the pallet.
3. Remove the storage stands from the aerator. Retain
them for storage use.
Note: The SR54-S and the SR70-S do not have
shipping stands.
4. Place the aerator on a flat, level surface with the
front roller on the ground and a 2 x 4 positioned
under the heads.
Qty.
1 Read before operating the aerator
1 Use to reference part numbers
4 Replacement spring wires
2 Replacement spring wires
6 Replacement spring wires
8 Replacement spring wires
4 Replacement spring wires
2 Replacement spring wires
4 Replacement spring wires
2 Replacement spring wires
1 View before operating the aerator
1 Read before operating the aerator
2
Connecting the Lower Link
Arms
Parts needed for this procedure:
2 Hitch pin
2 Lynch pin
Procedure
1. Back the tractor squarely up to the aerator until
the lower link arms are aligned with the mounting
brackets.
Note: The aerator gear box shaft should be in line
with the tractor PTO shaft (centered on the tractor).
If they are not in line, adjust the lower link arms,
from side to side until the shafts are aligned.
2. Make sure the PTO is disengaged.
3. Engage the parking brake, STOP the engine and
remove the key from the ignition. Wait for the
engine and all moving parts to STOP before leaving
the Operator's seat on the tractor.
Note: For maximum ground clearance, the hitch
pins should be secured in the aerator lower mounting
bracket holes, when so equipped. To determine
9
Use