Lubrication; Greasing The Bearings And Bushings - Toro 03170 Operator's Manual

Lubrication

Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings
and bushings daily when conditions
are dusty and dirty.)
Every 500 hours/Yearly (whichever
comes first)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. Bearings and bushings must be lubricated
daily when the operating conditions are extremely
dusty and dirty. Dusty and dirty operating conditions
could cause dirt to get into the bearings and bushings,
resulting in accelerated wear. Lubricate the grease
fittings immediately after every washing, regardless of
the interval specified.
The grease fitting locations and quantities are as follows:
• Rear cutting unit pivot (Figure 47)
Figure 47
• Front cutting unit pivot (Figure 48)
Figure 48
• SideWinder cylinder ends (2; model 03170 only)
(Figure 49)
• Steering pivot (Figure 50)
• Rear lift arm pivot and lift cylinder (2) (Figure 51)
42
Figure 49
Figure 50