Toro 03170 Operator's Manual page 20

1. Front carrier frame
3. Secure the mounting links to the front carrier frames
as follows:
• Secure the front mounting links to the middle
carrier frame holes with a bolt (3/8 x 2-1/4
inch), 2 flat washers, and a locknut, as shown in
Figure 17. Position a washer on each side of the
link when mounting. Torque the fasteners to 31
ft-lb (42 N-m).
• Secure the rear mounting links to the middle
carrier frame holes with a bolt (3/8 x 2-1/4
inch), 2 flat washers, and a locknut, as shown in
Figure 17. Position a washer on each side of the
link when mounting. Torque the fasteners to 31
ft-lb (42 N-m).
1. Front carrier frame
2. Front mounting link
3. Rear mounting link
Figure 16
Figure 17
4. Position the rear carrier frame (Figure 18) onto the
rear cutting unit.
1. Rear carrier frame
5. Secure the mounting links to the rear carrier frame
as follows:
• Secure the front mounting links to the carrier
frame holes with a bolt (3/8 x 2-1/4 inch), 2 flat
washers, and a locknut, as shown in Figure 19.
Position a washer on each side of the link when
mounting. Torque the fasteners to 31 ft-lb (42
N-m).
• Secure the rear mounting links to the rear carrier
frame holes with a bolt (3/8 x 2-1/4 inch), 2 flat
washers, and a locknut, as shown in Figure 19.
Position a washer on each side of the link when
mounting. Torque the fasteners to 31 ft-lb (42
N-m).
20
Figure 18