Controls System Maintenance; Adjusting The Traction; Control; Adjusting The Reel Control - Toro 04018 Operator's Manual

Figure 42
1. Tang washer
B. Using a 3/8 inch drive torque wrench,
rotate the idler bracket with 35-40 in.-lb. of
torque to set the belt tension (Figure 43).
While holding the torque wrench setting,
tighten the idler bracket mounting bolt
(The tang washer is installed to prevent the
belt from slipping.). Do not over-tension
the belt.
Figure 43
1. Traction drive belt
2. Idler bracket
C. Install the belt cover.
2. Idler bracket bolt
3. 3/8 inch Torque wrench
here
Controls System
Maintenance

Adjusting the Traction

Control

If traction control does not engage or it slips
during operation, an adjustment is required.
1. Move traction control to Disengaged position.
2. To increase cable tension, loosen front cable
jam nut and tighten back cable jam nut
(Figure 44) until a force of 12-16 lb. is required
to engage traction control.
Measure the force at the control knob.
Figure 44
1. Traction cable
3. Tighten front cable jam nut.
4. Check control operation.

Adjusting the Reel Control

If reel control does not engage or it slips during
operation, an adjustment is required.
1. Make sure traction control is properly adjusted;
refer to Adjusting the Traction Control.
2. To increase cable tension, loosen front cable
jam nut and tighten back cable jam nut
(Figure 45) (located on top of gear box)
until the reel cable force adds 7 to 10 lbs. of
additional handle force measured at the control
knob.
Note: If traction control handle force is
12 lbs., the combined traction and reel force
should be 19 to 22 lbs.
31
2. Service/parking brake cable