Table of Contents
Advertisement
3. Loosen interlock switch mounting fasteners
(Figure 28).
4. Place a .032" thick shim between the traction
lever and the interlock switch (Figure 28 ).
5. Tighten interlock switch mounting fasteners.
Recheck gap. The traction lever must not
contact the switch.
6. Engage traction lever and verify that the switch
loses continuity. Replace if required.
Important: Replace interlock switch
every 2 years.
Drive System
Maintenance
Checking the Transmission
Fluid Level
The transmission is filled at the factory with
approximately 94 fluid ounces of Mobil Dexron
lll automatic transmission fluid. Check fluid level
before the engine is first started and every 50
hours thereafter.
Note: The seals used in the transmission are
internally lubricated with grease. During initial
operation of mower, slight weeping of grease from
these seals will occur. Wipe off excess grease.
Important: Use only Mobil Dexron lll or
equivalent transmission fluids. Other fluids
could cause system damage.
1. Place the mower on its drums on a level
surface.
2. Remove the check/fill plug from the right-hand
side of the transmission (Figure 29).
The oil level should come to the bottom of
the fill hole. If it does not, add enough of
the proper oil type until the level reaches the
bottom of the fill hole.
Figure 29
1. Check/ll plug
3. Install the plug.
Changing the Transmission
Fluid
Change the transmission fluid after the first 25
hours of operation and every 2 years or 1500
hours, which ever occurs first thereafter.
Important: Use only Mobil Dexron lll or
equivalent transmission fluids. Other fluids
could cause system damage.
1. Place a drain pan at the rear of the machine.
2. Remove the drain plug from the rear of the
transmission (Figure 30).
Figure 30
1. Check/ll plug
3. Push down on the handle and tip the machine
back. Remove the check/fill plug from the
right-hand side of the transmission (Figure 30).
27
2. Drain plug
2. Drain plug
Hide quick links:
Advertisement
Table of Contents
