Adjusting The Handle; Installing The Transport; Wheels - Toro 04018 Operator's Manual

Figure 7
1. Spring
2. Spring end under the frame 4. Move the spring end under
Step
3

Adjusting the Handle

No Parts Required
Procedure
1. Remove hairpin cotters from ring pins on each
side of mower (Figure 8).
Figure 8
1. Ring pins
2. While supporting handle, remove ring pins
from each side and raise or lower handle to
desired operating position (Figure 8).
3. Reinstall ring pins and hair pin cotters.
3. Nut runner
the kickstand spacer.
Step
4

Installing the Transport

Wheels

Parts needed for this step:
Transport wheels (Optional Transport Wheel
2
Kit, Model 04123)
Procedure
1. Push kick stand down with foot and pull up
on handle support until kick stand has rotated
forward, over center (Figure 9).
Figure 9
1. Kick stand
2. Press wheel locking clip toward the center
of wheel and slide wheel onto hex shaft
(Figure 10).
12