Toro 30604 Operator's Manual page 27

Setting up the Center Mower Deck
1. Rotate the blade on each spindle until the ends face
forward and backward.
2. Measure from the floor to the front tip of the cutting
edge.
3. Adjust the shims (3 mm or 1/8 inch) on the front caster
fork(s) to match the height-of-cut decal
refer to Adjusting the Mower-Deck Pitch (page
Figure 26
1. Tensioning cap
2. Spacers
3. Shims
(Figure 26);
56).
4. Top axle-mounting hole
5. Caster wheel
Setting up the Wing Mower Decks
1. Rotate the blade of each spindle until the ends face
forward and backward.
2. Measure from the floor to the front tip of the cutting
edge.
3. Adjust the shims (3 mm or 1/8 inch) on front caster
arm(s) to match the height-of-cut decal
Note: For the outside blade spindle only, refer to
Adjusting the Mower-Deck Pitch (page
1. Front caster arm
2. Shims
Matching the Height of Cut Between
Mower Decks
1. Position blade side to side on outside spindle of both
wing mower decks.
2. Measure from the floor to the tip of the cutting edge
on both units and compare.
Note: These numbers should be within 3 mm (1/8
inch) of each other.
3. Add or remove shims (1/8 inch) as needed on side
castor wheels.
4. Check the measurement between the outside edges of
both wing mower decks and adjust as necessary.
27
(Figure
56).
Figure 27
3. Front caster fork
27).