Table of Contents
Advertisement
4. Secure each mounting link to carrier frame with a
3/8–16 x 2–1/4" lg capscrew, (2) flatwashers and a
locknut, as shown in figure 14. Position a washer on
each side of link when mounting. Torque to 31 ft–lb.
2
FRONT
Figure 14
1. Carrier frame
2. Mounting link
Mount Cutting Units
1. Slide a thrust washer onto each front lift arm pivot rod.
2. Slide cutting unit carrier frame onto pivot rod and
secure with a lynch pin (Fig. 15).
Note: On rear cutting unit, thrust washer to be positioned
between rear of carrier frame and lynch pin.
2
1
Figure 15
1. Thrust washer
2. Carrier frame
3. Grease all lift arm and carrier frame pivot points.
Important
Make sure hoses are free of twists or
sharp bends and rear cutting unit hoses are routed as
shown in Fig. 16. Raise cutting units and shift them to
the left (Model 03206 only). Rear cutting unit hoses
must not contact traction cable bracket. Re–position
fittings and / or hoses, if required.
1
3
3. Plug
3
3. Lynch pin
17
Figure 16
4. Route a tipper chain up thru slot in end of each carrier
frame. Secure tipper chain to top of carrier frame with a
capscrew, washer and locknut (Fig. 17).
1
Figure 17
1. Tipper chain
Advertisement
Table of Contents
