Servicing The Fuses - Toro 74448 Operator's Manual

Figure 36
1. Positive Battery Post
2. Negative Battery Post
3. Install the battery in the machine and connect the
battery cables; refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
Fuse:
• Main, F1-30 amp, blade-type
• Charge circuit, F2-25 amp, blade-type
• Optional head light kit, 10 amp, blade-type
1. Raise the seat to gain access to the fuse holder
(Figure 37).
2. To replace the fuses, pull out on the fuse to remove
it.
3. Install a new fuse (Figure 37).
3. Red (+) Charger Lead
4. Black (-) Charger Lead
1. Main, 30 amp
2. Charge circuit, 25 amp
3. For optional head light kit,
10 amp
32
Figure 37
4. Ignition switch
5. Throttle lever