Controls - Toro 74448 Operator's Manual

1. Rollbar
2. Fuel cap (both sides)
3. Seat belt
4. Motion control lever
5. Height-of-cut lever

Controls

Become familiar with all the controls before you start the
engine and operate the machine (Figure 3 and Figure 4).
1. Ignition switch
2. Motion control lever
3. Brake lever
4. Throttle control
5. Choke
Using the Hour Meter
The hour meter (Figure 5) records the number of hours
the engine has operated. It operates when the engine
Figure 3
6. Side discharge
7. Front caster wheel
8. Controls
9. Mower deck
10. Parking brake lever
Figure 4
6. PTO Switch
7. Height-of-cut lever
8. Fuel cap (both sides)
9. Hour meter
is running. Use these times for scheduling regular
maintenance.
1. Hour meter
Throttle Control
The throttle control has two positions: Fast and Slow.
Choke
Use the choke to start a cold engine.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the
electric clutch to drive the mower blades with the motion
control levers in the center, un-locked position. Pull the
switch up to engage the blades and release. To disengage
the blades, push the blade control switch (PTO) down.
Ignition Switch
This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Using the Fuel Shutoff Valve
The machine has 2 fuel tanks, one on the left side and
the other on the right side. Each tank connects to a
check valve and then to a tee. From there a common
fuel line leads to the engine (Figure 6).
Close the fuel shutoff valve before transporting or
storing the machine.
11
Figure 5