Stopping The Engine - Toro 74310 Operator's Manual

With 42in or 48in direct-collect cutting unit
Hide thumbs Also See for 74310:
Table of Contents

Advertisement

a warm engine, leave the choke in the O
position.
Figure 16
6. Turn the ignition key to the S
12). When the engine starts, release the key.
Important: Do not crank the engine continuously
for more than 10 seconds at a time. If the engine
does not start, wait 60 seconds between starting
attempts. Failure to follow these guidelines can
burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
7. If the choke is in the C
return choke to the O
warms up.
/O
PEN
position
(Figure
TART
/O
position, gradually
LOSED
N
/O
position as the engine
PEN
FF

Stopping the Engine

FF
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Important: Make sure that the fuel-shutoff valve is
closed before transporting or storing the machine, as
fuel leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
1. Disengage the PTO.
2. Move speed-control lever to the N
3. Engage the parking brake.
4. Place the throttle in the middle position.
5. Allow the engine to run for a minimum of 15 seconds,
then turn the ignition switch to the O
stop the engine.
6. Remove the key to prevent children or other
unauthorized persons from starting engine.
21
position.
EUTRAL
position to
FF
Figure 17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

74312Z master 8000 series74313

Table of Contents