Throttle Control; Motion Control Levers; Ignition Switch - Toro 74444 Operator's Manual

displayed in the area where the hours are normally
displayed.
The battery light turns on when the ignition is turned
on and when the charge is below the correct operating
level (Figure 6).
1. Safety interlock symbols
2. Hour meter

Throttle Control

The throttle control is variable between Fast and Slow.
Choke
Use the choke to start a cold engine.

Motion Control Levers

The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (near the engine) when
transporting or storing the mower.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the
electric clutch to drive the mower blades with the motion
control levers in the center, un-locked position. Pull the
switch up to engage the blades and release. To disengage
the blades, push the blade control switch (PTO) down.

Ignition Switch

This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Figure 6
3. Battery light
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
12