Operation; Using The Rollover Protection System (Rops) - Toro 74410 Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
Using the Rollover Protection
System (ROPS)
Warning
To avoid injury or death from a rollover, keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured
with the seat latch.
Warning
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is in
the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (e.g.,
branches, doorways, and electrical wires) before
driving under any objects and do not contact
them.
Important
Lower the roll bar only when absolutely
necessary.
1. To lower the roll bar, loosen the front handles (Fig. 2).
1
Figure 2
1. Front handle
2. Remove the hairpin cotter pins and remove the 2 pins
(Fig. 3).
1
1. Roll bar
2. Raised position
3. Lower the the roll bar to the down position.
Note: There are 2 down positions. See Figure 4 for the
positions.
1. Full down position
4. Install the 2 pins and secure them with the hairpin cotter
pins (Fig. 3).
Important
m-7406
the raised position.
Important
secured with the seat latch.
5. To raise the roll bar, remove the hairpin cotter pins and
remove the 2 pins (Fig. 3).
6. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotter pins
(Fig. 3).
15
3
4
Figure 3
3. Pin
4. Hairpin cotter pin
Figure 4
2. Down position with
Always use the seat belt with the roll bar in
Ensure that the rear part of the seat is
2
m-7431
2
1
m-7432a
bagger installed