Cleaning And Storage - Toro 22300 Operator's Manual

Cleaning and Storage

1. Lower the loader arms and turn the ignition key
to "OFF" to stop the engine. Remove the key.
2. Remove dirt and grime from the external parts of
the entire machine, especially the engine. Clean
dirt and chaff from the outside of the engine's
cylinder head fins and blower housing.
IMPORTANT: You can wash the machine
with mild detergent and water. Do not
pressure wash the machine. Avoid excessive
use of water, especially near the control panel,
engine, hydraulic pumps and motors.
3. Service the air cleaner; refer to Air Cleaner,
page 20.
4. Grease the machine; refer to Greasing and
Lubrication, page 24.
5. Change the crankcase oil; refer to Engine Oil,
page 22.
6. Change the hydraulic fluid; refer to Hydraulic
System, page 26.
7. Remove the spark plug(s) and check its
condition; refer to Spark Plug, page 23. With the
spark plug(s) removed from the engine, pour two
tablespoons of engine oil into the spark plug
hole. Now use the starter to crank the engine and
distribute the oil inside the cylinder. Install the
spark plug(s). Do not install the wire on the
spark plug(s).
8. Check the tire pressure; refer to Tire Pressure.
9. Charge the battery; refer to Battery page 28.
10. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank
(1 oz. per gallon).
A. Run engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the
fuel tank; refer to Fuel Tank, page 25.
C. Restart engine and run until it stops.
Repeat, on "CHOKE" until engine will not
restart.
D. Dispose of fuel properly. Recycle according
to local codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
11. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
12. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
13. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover
the machine to protect it and keep it clean.
Maintenance
29