Specifications; Attachments - Toro 22305 Operator's Manual

9. Slowly pour electrolyte into each cell until the level is
once again up to the upper line on the battery case
(Fig. 4) and install the covers.
10. Install the battery into the chassis (Fig. 3).
11. Secure the battery with the bar and wing nuts removed
previously (Fig. 3).
12. Using the bolt and wing nut supplied with the battery,
connect the positive (red) cable to the positive (+)
battery post (Fig. 3). Slide the rubber cover over the
battery post.
13. Using the bolt and wing nut supplied with the battery,
connect the negative (black) cable to the negative (–)
battery post (Fig. 3).
Note: Ensure that the battery cables do not contact any
sharp edges or each other.
14. Install the hood; refer to Installing the Hood, page 21.

Specifications

Overall width
Overall length
Overall height
Weight
Rated operating capacity (with
200 lb. operator and std.
bucket)
Tipping capacity (with 200 lb.
operator and st. bucket)
Wheelbase
Dump height (with std. bucket)
Reach—fully raised (with std.
bucket)
Height to hinge pin (std bucket
in highest position)
Specifications and design are subject to change without
notice.

Attachments

Many attachments are available for use with the traction
unit. These attachments allow you to perform many
different functions with the traction unit such as hauling
materials, digging holes, grading, and more. Contact your
Toro dealer for a list of all approved attachments and
accessories.
Important
40.5 in. (103 cm)
60.0 in. (152 cm)
49.0 in. (125 cm)
1567 lb. (711 kg)
515 lb. (234 kg)
l030 lb. (467 kg)
28 in. (71 cm)
47 in. (120 cm)
26.0 in. (66 cm)
66.0 in. (168 cm)
10
Use only Toro approved attachments.