Servicing The Air Cleaner - Toro 22305 Operator's Manual

2. Secure the hood by pushing the locking tabs forward
and down (Fig. 17).
Greasing the Traction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Fig. 18 and 19).
Figure 18
Figure 19
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.

Servicing the Air Cleaner

Clean the primary filter every 25 operating hours. Replace
the primary and secondary filter yearly.
Note: Service the air cleaner more frequently if operating
conditions are extremely dusty or sandy.
Removing the Filter
1. Lower the loader arms and stop the engine. Remove
the key.
2. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Fig. 20).
3. Clean the inside of the air cleaner cover with
compressed air.
4. Gently slide the primary filter out of the air cleaner
body (Fig. 20). Avoid knocking the filter into the side
of the body. Do not remove the safety filter, unless you
intend to replace it as well.
5. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter. Holes in the filter will appear as bright spots.
If the filter is damaged, discard it, otherwise clean it.
Important
Never attempt to clean the safety filter. If
the safety filter is dirty, then the primary filter is damaged
and you should replace both filters.
m–4396
m–4387
1. Latches
m–4056
2. Air cleaner cover
3. Air filter body
Cleaning the Primary Filter
Blow compressed air from the inside to the outside of the
primary filter.
Important
Do not exceed 100 psi. and keep the hose
at least 2 in. from the filter.
22
3
4
5
2
1
Figure 20
4. Primary filter
5. Safety filter
1