Securing The Traction Unit For Transport; Maintenance; Recommended Maintenance Schedule - Toro 22305 Operator's Manual

Caution
Hydraulic couplers, hydraulic lines/valves, and
hydraulic fluid may be hot. If you contact hot
components you may be burned.
Wear gloves when operating the hydraulic
couplers.
Allow the traction unit to cool before touching
hydraulic components.
Do not touch hydraulic fluid spills.
7. Push the attachment female connector into the male
connector on the traction unit.
8. Confirm that the connection is secure by pulling on the
hoses.
9. Move the auxiliary hydraulics lever to neutral.
Removing an Attachment
1. Lower the attachment to the ground
2. Stop the engine.
3. Disengage the quick attach pins by turning them to the
outside.
4. If the attachment uses hydraulics, move the auxiliary
hydraulics lever forward, backward, and back to
neutral to relieve pressure at the hydraulic couplers.

Maintenance

Note: Determine the left and right side of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
8 hours
25 hours
100 hours
Maintenance Procedure
Grease the traction unit
Check engine oil level
Check for loose fasteners
Check tire pressure (20 psi.)
1
Clean primary air filter
Check hydraulic oil level
Inspect hydraulic lines for leaks
1, 2
Change engine oil
Check battery electrolyte level
Check wheel lug nut torque (50 ft.-lb)
Check battery cable connections
20
5. If the attachment uses hydraulics, slide the collar back
on the hydraulic couplers and disconnect them.
Important
Connect the attachment hoses together to
prevent hydraulic system contamination during storage.
6. Install the protective covers onto the hydraulic
couplers on the traction unit.
7. Start the engine, tilt the mount plate forward, and back
the traction unit away from the attachment.
Securing the Traction Unit for
Transport
When transporting the traction unit on a trailer, always use
the following procedure:
Important
Do not operate or drive the traction unit on
roadways.
1. Lower the loader arms.
2. Stop the engine.
3. Secure the traction unit to the trailer with chains or
straps using the operator platform support openings to
secure the rear of the traction unit and the loader
arms/mount plate to secure the front of the traction
unit.
3