Servicing The Engine Oil And Filter - Toro 30411 Groundsmaster 4100-D Operator's Manual

the new filter by applying pressure to the outer
rim of the element to seat it in the canister. Do
not apply pressure to the flexible center of the
filter.
Important: Never attempt to clean the
safety filter (Figure 47). Replace the safety
filter with a new one after every three
primary filter services.
Figure 47
1. Air cleaner safety lter
4. Clean the dirt ejection port located in the
removable cover. Remove the rubber outlet
valve from the cover, clean the cavity and
replace the outlet valve.
5. Install the cover orienting the rubber outlet
valve in a downward position - between
approximately 5:00 to 7:00 when viewed from
the end.
6. Reset the indicator (Figure 45) if it shows red.
Servicing the Engine Oil and
Filter
Change the oil and filter initially after the first 50
hours of operation; thereafter change the oil and
filter every 150 hours.
1. Remove either drain plug (Figure 48) and let
the oil flow into a drain pan. When the oil
stops, install the drain plug.
Figure 48
1. Engine oil drain plug
2. Remove the oil filter (Figure 49). Apply a light
coat of clean oil to the new filter seal before
screwing it on. Do not overtighten.
Figure 49
1. Engine oil lter
3. Add oil to the crankcase; refer to Checking the
Engine Oil.
39