Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual page 65

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
Step 3 Check whether the contact strips are clean. If they are not clean and the dirt cannot be removed,
replace it with a new RJ45 connector.
Figure 5-35 Dirt on a contract strip
Step 4 Check whether the contact strips and the plastic separators are well aligned and intact. If a
separator is skew and cannot be fixed, replace it with a new RJ45 connector.
an unqualified piece.
Figure 5-36 Skew plastic separators
Step 5 Hold the connector with the side facing towards you, and check whether you can see the cross-
sections of the wires. Ensure that the ends of the wires are in good contact with the edge of the
RJ45, and that the contact strip blade extends beyond the ends of the wires and is crimped with
the wires. If not, replace the connector.
Figure 5-37 Wires not in good contact with the edge of the RJ45
Issue 11 (2015-05-18)
Figure 5-35
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
shows an unqualified piece.
Figure 5-37 shows an unqualified piece.
5 Appendix
Figure 5-36 shows
58