Adjustable Bottle Holder; Installing The Adjustable Bottle Holders; Odour Filter; Chill Compartment - Blomberg MDND 1880 Operating Instructions Manual

Hide thumbs Also See for MDND 1880:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Adjustable bottle holder

You can use the adjustable bottle
holders without sacrificing any place
by sliding them to left or right or by
interlacing them.
Horizontal wires
Installing the adjustable
bottle holders
You mast install the holders into the
channels in the following order in order
to use them appropriately.
-Bottle holder that will remain at the
left side must be installed to the front
channel in the rail.
-Bottle holder that will remain in the
middle must be installed to the middle
channel in the rail.
-Bottle holder that will remain at the
rear side must be installed to the rear
channel in the rail.
Verify the position of the horizontal
wires during installation.

Odour filter

Odour filter in the air duct of the fridge
compartment prevents the build-up of
unpleasant odours in the refrigerator.

Chill compartment

You can increase the inner volume
of your refrigerator by removing the
desired snack compartment. Pull the
compartment towards yourself until it
is stopped by the stopper. Raise the
front part for approximately 1 cm and
pull the compartment towards yourself
again to remove it completely.
You can place the food that you want
to freeze in order to prepare them for
freezing in these compartments. You
can also use these compartments
if you want to store your food at a
temperature a few degrees below the
fridge compartment.
15
EN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mdnd 1880a+++Mdnd 1881a++

Table of Contents