Remove A Memory Card; Charge The Battery - Nokia 6710 Navigator User Manual

2. Place the card
in the slot with
the contact
area facing
down (2).
3. Push the card
gently to lock it
into place.
Close the slot
cover (3).

Remove a memory card

Important: Do not remove the memory card during
an operation when the card is being accessed. Doing so may
damage the memory card and the device, and corrupt data
stored on the card.
1. Press the power key briefly, and select
card > Yes.
2. Open the memory card slot cover.
3. Press the memory card gently to release it.
4. Pull the card out, and press OK.
5. Close the slot cover.

Charge the battery

Your battery has been partially charged at the factory. If the
device indicates a low charge, do the following:
1. Connect the charger to a wall outlet.
10
2. Connect the
3. When the
You can also charge the battery with a USB data cable
connected to a compatible computer.
1. Connect the USB data cable to a USB port of a computer
2. When the battery is fully charged, disconnect the USB data
Remove memory
USB charging efficiency varies significantly. In some cases, it
may take a very long time for charging to start and the device
to start functioning. You do not need to charge the battery
for a specific length of time, and you can use the device while
it is charging. If the battery is completely discharged, it may
take several minutes before the charging indicator appears
on the display or before any calls can be made.
charger to the
device.
device
indicates a full
charge,
disconnect the
charger from
the device,
then from the
wall outlet.
and to your device.
cable.
© 2009 Nokia. All rights reserved.