Panasonic U-26PE1U6 Technical Data & Service Manual page 294

<Procedure of CZ-RTC3 / CZ-RTC5>
1. Keep pressing the
for 4 or more seconds.
The "Maintenance func" screen appears on the LCD display.
2. Press the
menu.
If you wish to see the next screen instantly,
press the or
Select "9. Auto address" on the LCD display
and press the
3. The "Auto address" screen appears on the LCD
display.
Change the "Code no." to "A1" by pressing the
or
4. Select the "O/D unit no." by pressing the
Select one of the "O/D unit no." for automatic address by pressing the
Then press the
Approximately about 10 minutes are required.
When automatic address setting is completed, the units return to normal stopped status.
<Procedure of CZ-RTC4>
1 Press the remote controller timer time
button at the same time.
(Press and hold for 4 seconds or longer.)
Next, press either the temperature setting
2
button. (Check that the item code is "A1".)
3 Use either the
perform automatic address setting.
4 Then press the
(Automatic address setting for one refrigerant system
begins.) (When automatic address setting for one
system is completed, the system returns to normal
stopped status.)
<Approximately 4 – 5 minutes is required.>
(During automatic address setting, "
displayed on the remote controller.
This message disappears when automatic address
setting is completed.)
5 Repeat the same steps to perform automatic address
setting for each successive system.
6
, and
or button to see each
button.
button.
button.
button.
button and
button to set the system No. to
button.
" is
buttons simultaneously
Maintenance func 20:30 (THU)
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel. Page [ ] Confirm
Auto address 20:30 (THU)
Code no. O/D unit no.
A1 1
Sel. Next
or button.
/
2
1
6-10
[ ]
START
CZ-RTC3 / CZ-RTC5
or button.
CZ-RTC4
4
6. Test run
20:30 (THU)
4
3